"; _cf_contextpath=""; _cf_ajaxscriptsrc="/cfthorscripts/ajax"; _cf_jsonprefix='//'; _cf_websocket_port=8578; _cf_flash_policy_port=1244; _cf_clientid='0ACA3E7FB22181AB675514F9A7F3B492';/* ]]> */
Linear Translation Stages: 2" (50 mm) Travel, Manual, Crossed Roller Bearings
Differential Drive Stage
Micrometer Drive Stage
Click to Enlarge
LNR50P4 Base Plate
Click for Details
XYZ Configuration Using Three LNR50M Stages with Base Plate LNR50P1 and Right-Angle Bracket LNR50P2
Click to Enlarge
LNR50P2 Right-Angle Bracket
TravelMax Steel Stages
Although these stages are supplied pre-configured with an actuator, these can be easily replaced if the application requirements change. Please see our compatible actuators subgroup below for details of other compatible actuators such as motor or piezo drives.
These stages offer stability, long travel, and high load capacity as well as flexible drive options, making them an ideal solution for all translation applications. Designed with the highest quality linear rails available, the performance is further enhanced by utilizing thermally matched materials that ensure stability, even in less-than-ideal conditions. The rigidity of the all-steel construction, along with the heavy-duty cross-roller bearings, provides uniform performance over the entire 2" (50 mm) range of motion.
Two drive options are available depending on application requirements. The standard micrometer supplied with the LNR50M provides a 2" range with a thread pitch of 0.1 mm. The Vernier provides graduations every 10 µm. The LNR50DD is equipped with a differential drive. The coarse adjustment provides 0.5 mm per revolution while the fine adjustment provides 50 μm per revolution. A Vernier scale on the differential drive has graduations every 1 µm.
Wide Range of Mounting Options
The LNR50P4 base plate provides additional mounting options and provides extra clearance between the stage and the work surface (e.g., when fitting motor drives). Tapped holes match up to the two counterbored clearance holes mentioned above, and four slotted holes allow the LNR50P2 angle bracket to be attached directly. The base plate measures 100 mm x 145 mm x 12 mm.
The LNR50P2 angle bracket allows the LNR stage to be mounted vertically. When combined with the LNR50P4 described above, it can be used to build an XZ, YZ, or XYZ configuration.